Fitting under a counter Levelling
(kitchen worktop or sink)Good levelling is essential for correct closure and sealing of
By removing the machineOs worktop, you can install it under athe door.
close fitting sink unit or a pre-existing top, providing theWhen the appliance is correctly levelled, the door will not catch
dimensions of the recess correspond to those shown in theon either side of the cabinet.
picture.
If the door does not close correctly, loosen or tighten the
adjustable feet until the machine is perfectly level.
570 - 600
820
600
IN05
Proceed as follows:
Remove the machineOs worktop by unscrewing the two rear
retaining screws, pull from the front and slide out the rear
slots, lifting the worktop.
Insert the machine after adjusting height and levelling with the
adjustable feet. When inserting the machine, ensure that the
water inlet and drain hoses are not kinked or squashed.
If the dishwasher is later used as a free-standing appliance,
the original worktop must be re-mounted.
The plinth on free-standing appliances is not adjustable.
Technical specifications
DimensionsWidth60 cm
Height with worktop85 cm
Height without worktop82 cm
Max depth61 cm
Electrical connection:Information on the electrical connection is given on the rating plate on the
Voltageinner edge of the dishwasherOs door on the right.
Overall power
Fuse
Water supply connection:cold water
Water supply pressure:Maximum50 kPa (0.5 bar)
Maximum800 kPa (8 bar)
Capacity12 place settings
This appliance complies with the following E.E.C. Directives:
- 73/23 or 19.2.73 (Low Voltage Directive) and subsequent modifications;
- 89/336 or 3.5.89 (Electromagnetic Compatibility Directive) and subsequent modifications.
7 |
ACEC
